Machine outer frame made in stainless steel Aisi 304, not covered type , to avoid rust problems due to chemicals.
Inside drum build in stainless steel AISI 316, passing through shaft supported in both sides of the machine by great dimension bearings.
Drum divided into
3 fixed compartments (RCT 100-300),
4 fixed compartments (RCT 360-500).
External doors equipped with electric and pneumatic safety devices.
Sampling door placed in the door frontal side.
Tempered glass windows for bath liquor visual control placed in the frontal side of the machine.
Automatic alignment between drum and external door.
Beaters of proper shape and dimensions in order to guarantee the best movement of garments inside the drum.
Drum punching properly designed to allow a perfect bath exchange.
Drum treated with special polishing material in order to remove any possible roughness and avoid the problem of thread pulling from the garments.
Automatic control of thermal cycles.
N°2 water inlet with pneumatic valves;
Water inlet controlled by litre counter.
N°1 manual products tank to introduce products into the machine.
Upon request the machine can be equipped with a colour kitchen such as: n°1 tank for dyestuff preparation with mixer, indirect heating by means of a coil and level probes. N°1 tank for chemicals with level probes.
The introduction into the machine is made by means of a pump.
Electrical panel connected with the machine control board.
Master-slave system that allows to couple two machines. In this case is possible to dye using the some dye bath.
Electrical board containing
all power and auxiliary components.
Control board with video terminal capable to store up to 90 programs of 50 steps each and machine control. Switch and buttons to control the machine.
